Palms West Amateur Radio Club

Sunspot numbers were lower again this week, with the averagedeclining from 143.6 two weeks ago to 118.7 last week and now 68this week. Average daily solar flux sank 8 points from 153.6 lastweek to 145.6.Six new sunspot groups emerged over the week, one on March 17,another March 18, three more on March 19, one more on March 21 andanother on March 22.Predicted solar flux is 150, 145 and 145 on Ma... [...]

The Federal Emergency Management Agency (FEMA) has released a final version (March 2023) of the National Incident Management System (NIMS) Information and Communications Technology (ICT) Functional Guidance. The guidance, which provides a framework for communications resources within incident management, officially includes support from amateur radio operators. The expanded Communications Unit ... [...]

Six new sunspot groups emerged over the past week, two on March 9,another on March 10, one more on March 12, and another two on March14.Sunspot numbers and solar flux declined this week.Average daily sunspot numbers softened from 143.6 to 118.7, andaverage daily solar flux from 181.6 to 153.6.Predicted solar flux is 135, 140, 138, and 135 on March 17-20, then132, 132 and 130 on March 21-23, 155... [...]

I first tried WSPR out in 2009, with a Signalink USB interface attached to my FT-817 and PC. For anyone interested in QRP and QRPp, the process of being able to decode a signal that is up to about 34dB below the noise level is quite fascinating. Morse code, sent by way of CW, engages […] [...]

When I built the VE7BPO DC Receiver Mainframe recently, it wasn’t intended to end up as a final finished project. The intention was more to have it as part of an experimental platform. The little box that contains the DBM, diplexer, and AF amplifier that make up the mainframe will most likely stay largely the […] [...]

Please note that the above photo is of my SW200, though Rod’s no doubt looks exactly the same.   A few months back, I received this note from Rod KQ6F – Hi Dave – I very much enjoyed your review on this product.  It was largely the reason I bought one.  My application is AM […] [...]

This will be a very brief post, and in no way constitutes a review. It’s barely even an “initial impressions” type of post. It’s just that I’ve been wanting a C Crane Skywave SSB for a while now, recently purchased one, and wanted to tell you! I’m sure many readers will identify with the search […] [...]

To many, this will be just another Si5351 VFO project, with nothing to distinguish it from the others. In fact, that’s exactly what it is. The “how to” of connecting an Arduino board to an Si5351 board, wiring up a display, and loading the firmware, is straightforward, and well established. To me though, it was […] [...]